RP2019

New Batteries Installing

1. To get started, insert one of your backup keys into the keyhole. Push the key in and rotate the key 60 degrees clockwise to open the safe.
2. With the safe unlocked, locate and remove the battery cover under the keypad.
3. Connect a new 9V alkaline battery (not included) to the battery connecting cap matching the polarity (+/-) indicated.
4. When the battery is connected correctly, the keypad will light up with a beep.

Low Battery Warning

• The batteries need to be replaced when the keypad flashes RED 10 times with 10 beeps during electronic unlock.
• A built-in USB Type-C port on the left side of the safe can be used when the battery is depleted without the keys. This port is for emergency use only, not for long-term use.
• You can simply plug a USB Type-C cable (not included) into the port to electronically unlock the safe as normal. It cannot be used for charging.

IMPORTANT:

• Do not place or store the backup keys inside the safe at any time.
• Use a new 9V alkaline battery. Non-alkaline batteries may prevent the safe from functioning properly.
• The safe locks automatically when the lid is fully closed.

Master Code Programming

NOTE :

• Programming a new code will overwrite your previous code.
• Your code can be a minimum of 3 digits and a maximum of 8 digits.
• Two keys cannot be pressed simultaneously.

1. Enter default code 1-2-3-4 on the keypad to open your safe.
2. With the safe open, press the Program Button once by using Button Tool, until the keypad flash BLUE once with a beep.
3. Enter your NEW master code within 10 seconds.
4. Simply press the Program Button again, the keypad flash BLUE 2 times with 2 beeps. This tone confirms that the passcode has been reset.
5. Now test the code. If you made a mistake during setting, the keypad will flash RED 5 times with 5 beeps, and the new code will not work, simply start over from Step 2.

Lock-Down System

• If an incorrect code is entered 3 times in a row, the safe will go into a lockdown mode for 5 minutes.
• During this time, the keypad will be temporarily disabled. The safe can still be opened using the backup key override.
• After 5 minutes, the safe will automatically resume its normal operation.

Silent Mode Setting

Press and hold the number "1" for 3 seconds until the keypad flash BLUE once to mute the electronics. To unmute, repeat this step.

Security Cable Using

1. Loop the security cable around a secured object.
2.  Run the end of the cable through the eyelet on the other end and pull tightly around the object.
3. Insert the end of the security cable into the fully enclosed cable mount inside your safe.
4. Make sure the safe closes with the cable secured in the cable mount.

Mounting Screws Using

• Place the safe on a flat surface where you want to mount it.
•  Mark the drill holes with a pencil and drill pilot holes.
•  Position the safe and insert screws through the safe into the pilot holes. Tighten the screws.

IMPORTANT: If the safe is mounted vertically with the door facing upwards, the safe will not open completely due to the weight of the safe. The door opens downwards or to the side when the safe is mounted vertically.